Ensemble RXTX - Bill of Materials
Band: 30, 20,
17m
Bill of Materials Pages
The components in this kit have been organized in these pages into three different presentations:
- Full Kit Inventory: lists all component counts included in the kit (even though some may nbot be required, depending upon the band option selected)
- Band-Specific BOM Cross=reference: lists each part, by designation (e.g., R01, C01, T01, etc) and showing, for each part, the Build Stage in which the part is used.
-
Band-Specific BOM: (this page) lists component counts required to support the selected band option
In addition, each build stage and each build step therein will present a stage/step-specific BOM for the selected Band Option.
DX Shipments Are in 2 Mailings
If you are a non-US builder, please note that Ensemble kit shipments to DX locations are done in two mailings:
- The first mailing includes the circuit board, ICs and capacitors.
- The second mailing includes the resistors, connectors, cores/wire, and hardware.
Ferrites
The kit is furnished with a sufficient variety of toroids to enable the builder to build it for any one of the four major "bands". The correct count of ferrites (toroids and binocular cores is as follows:
Ferrite Type | Quantity | Color/O.D. |
---|---|---|
T25-2 | 2 | Red/0.25" |
T25-6 | 2 | Yellow/0.25" |
T30-2 | 4 | Red/0.3" |
T30-6 | 2 | Yellow/0.3" |
T37-2 | 2 | Red/0.37" |
T37-6 | 2 | Yellow/0.37" |
BN-43-2402 | 5 | n/a |
BN-61-2402 | 3 | n/a |
Note that the binocular cores are of two different types (type 43 and type 61). They have NO distinguishing markings and come in the kit in two separate bags. To be safe, you should decide which type to mark and then place an identifying marking (or piece of tape) on the binocular cores of the selected type just in case the cores get mixed up. Once they are out of their bags, you can easily get them mixed up!.
Note also that the one 100k 1/6W 5% resistor is called for (it is R-Test in the TX OpAmps stage) in performing a test and is NOT included with the kit.
There has been considerable discussion on the Softrock40 Group concerning matching of the BS170s to be used in the PA Stage as Q7 abd Q8, The data sheet for the BS170 shows a very wide tolerance for the Gate Threshold Voltage. It seems in most cases this is fairly tightly controlled but some vary from "typical" while still being well within the actual specification. Some randomly selected ones have given variations Tony considers excessive.. Alan, G4ZFQ, has summarized the design of a simple test circuit you might want to consider using in selecting the best matched pair of BS170s out of the batch provided in the kit
Ensemble RXTX Bill of Materials
The following table shows counts for each component required for the Ensemble RXTX (30, 20, 17m band option).
Check | Type | Category | Component | Count | Marking | Image |
---|---|---|---|---|---|---|
[ ] | boardhdw | HDW | #4 nylon washer | 1 | ||
[ ] | boardhdw | HDW | 4 X #4-40 hdw (nut, bolt, washer, spacer) | 1 | ![]() | |
[ ] | Capacitor | Ceramic | 82 pF | 2 | 82J | ![]() |
[ ] | Capacitor | Ceramic | 100 pF 5% | 4 | 101 | ![]() |
[ ] | Capacitor | Ceramic | 150 pF 5% | 2 | 151 (may be blue or tan) | ![]() |
[ ] | Capacitor | Ceramic | 180 pF 5% | 1 | 181 | ![]() |
[ ] | Capacitor | Ceramic | 220 pF 5% | 4 | 221 | ![]() |
[ ] | Capacitor | Ceramic | 330 pF 5% | 2 | 331 | ![]() |
[ ] | Capacitor | Ceramic | 1000 pF 5% | 2 | 102 | ![]() |
[ ] | Capacitor | SMT 1206 | 0.01 uF | 7 | (smt) no stripe | ![]() |
[ ] | Capacitor | Ceramic | 0.01 uF | 1 | 103 | ![]() |
[ ] | Capacitor | Ceramic | 0.022 uF 5% | 4 | 223 | ![]() |
[ ] | Capacitor | Ceramic | 0.047 uF 5% | 2 | 473 | ![]() |
[ ] | Capacitor | SMT 1206 | 0.1 uF | 22 | (smt) black stripe | ![]() |
[ ] | Capacitor | Ceramic | 4.7 uF 10% 16V X7R RAD | 7 | 475 | ![]() |
[ ] | Capacitor | Electrolytic | 10uF/16 VDC | 17 | ![]() | |
[ ] | connector | Socket | socket, machine, 8 pin | 1 | ![]() | |
[ ] | connector | Jack-RA | 3.5mm stereo jack - PCB mount (rt-angle) | 3 | ![]() | |
[ ] | Connector | Jack-RA | DC Power Jack PCB Mount (rt-angle) 2.5mm | 1 | ![]() | |
[ ] | Connector | BNC-RA | bnc connector pcb (rt-angle) | 1 | ![]() | |
[ ] | Connector | Plug | DC Power Plug 5.5/2.5mm Pos Ctr | 1 | ![]() | |
[ ] | connector | Jack-RA | USB-B pcb jack (rt-angle) | 1 | ![]() | |
[ ] | Diode | Axial | 1N4003 | 2 | 1N4003 | ![]() |
[ ] | Diode | Axial | BZX55C3V3 3.3V zener diode | 2 | BZX55C | ![]() |
[ ] | heatsink | TO-18 | heatsink for driver transistor | 1 | ![]() | |
[ ] | Heatsink | TO-220 | TO-220 heatsink for flat transistors | 1 | ![]() | |
[ ] | Heatsink | Misc | TO-220 heatsink Silpad | 1 | ![]() | |
[ ] | IC | TO-92 | LM78L05 voltage regulator | 1 | LM78L05 | ![]() |
[ ] | IC | SOIC-16 | FST3253 mux/demux switch | 2 | FST3253 | ![]() |
[ ] | IC | SOIC-8 | TLV2462CD dual opamp | 2 | TVL2462CD | ![]() |
[ ] | IC | SOIC-8 | LT6231 dual op-amp | 1 | LT6231 | ![]() |
[ ] | IC | SOIC-14 | 74AC74 Dual D FF | 1 | 74AC74 | ![]() |
[ ] | IC | DIP 8 | ATtiny 85-20 PU w/V15.12 Firmware | 1 | AVR ATTINY85-20PU | ![]() |
[ ] | IC | DIP-4 | LTV-817 Opto-Isolator | 1 | LTV 817 | ![]() |
[ ] | IC | SOT-23-5 | LP2992AIM5-3.3V regulator | 1 | LFEA | ![]() |
[ ] | IC | I2C | Si570 Programmable Oscillator | 1 | SiLabs 570 | ![]() |
[ ] | inductor | Binocular core | BN-43-2402 (no markings!) | 2 | none | ![]() |
[ ] | inductor | Toroid | T25-6 toroid core | 2 | yellow | ![]() |
[ ] | inductor | Toroid | T30-6 toroid core | 2 | yellow | ![]() |
[ ] | inductor | Toroid | T37-6 toroid core | 2 | yellow | ![]() |
[ ] | inductor | Toroid | T37-2 toroid core | 2 | red | ![]() |
[ ] | inductor | Binocular core | BN-61-2402 (no Markings!) | 3 | none | ![]() |
[ ] | inductor | Xfrmr | 0.6uH: 14T/2x7T bifilar #30 on T25-6 (yellow) 8" | 1 | yellow | |
[ ] | Inductor | Coil | 0.6uH: 14T #26 on T37-6 (yellow) | 2 | yellow | |
[ ] | Inductor | Coil | 0.78uH 17T #30 on T25-6 (yellow) | 1 | yellow | |
[ ] | inductor | Coil | 0.9uH: 15T #26(10 in) on T37-2 (red) | 2 | red | |
[ ] | Inductor | Coil | 1.6uH 21T #30 on T30-6 (yellow) | 1 | yellow | |
[ ] | Inductor | Xfrmr | 1.74uH 11T bifilar/22T #30 on T30-6(yellow) | 1 | yellow | |
[ ] | Inductor | xfrmr | 4T bifilar #30 on BN-61-2402 | 1 | ||
[ ] | Inductor | Xfrmr | 2T Bifilar #30 on BN-43-2402 | 1 | ||
[ ] | Inductor | Xfrmr | 3T bifilar/5T #30 0n BN-61-2402 | 1 | ||
[ ] | Inductor | Xfrmr | 6T/3T bifilar #30 on BN-61-2402 | 1 | ||
[ ] | Inductor | Choke | 4T #26 on BN-43-2402 | 1 | ||
[ ] | Resistor | 1/4W | 2.2 ohm 1/4W 5% | 2 | red-red-gld-gld | ![]() |
[ ] | Resistor | 1/4W | 10 ohm 1/4W 1% | 4 | br-blk-blk-gld-br | ![]() |
[ ] | Resistor | 1/4W | 22.1 ohm 1% | 1 | red-red-brn-gld-brn | ![]() |
[ ] | Resistor | 1/4W | 33.2 ohm 1% | 1 | ora-ora-red-gld-brn | ![]() |
[ ] | Resistor | 1/4W | 49.9 ohm 1% | 6 | yel-wht-wht-gld-brn | ![]() |
[ ] | Resistor | 1/4W | 56.2 1/4W 1% | 1 | grn-blu-red-gld-brn | ![]() |
[ ] | Resistor | 1/6W | 68 1/6W 5% | 4 | bl-gry-blk-gld | ![]() |
[ ] | Resistor | 1/4W | 68.1 1/4W 1% | 1 | blu-gry-brn-gld-brn | ![]() |
[ ] | Resistor | 1/6W | 100 1/6W 5% | 2 | br-blk-br-gld | ![]() |
[ ] | Resistor | 1/4W | 221 1/4W 1% | 3 | red-red-brn-blk-brn | ![]() |
[ ] | Resistor | 1/4W | 475 1/4W 1% | 2 | y-v-grn-bl-br | ![]() |
[ ] | Resistor | 1/4W | 1 k 1/4W 1% | 3 | br-blk-blk-br-br | ![]() |
[ ] | Resistor | 1/6W | 2.2k 1/6W 5% | 4 | red-red-red-gld | ![]() |
[ ] | Resistor | 1/4W | 2.21 k 1/4W 1% | 5 | r-r-br-br-br | ![]() |
[ ] | Resistor | 1/4W | 3.32 k 1/4W 1% | 1 | ora-ora-red-brn-brn | ![]() |
[ ] | Resistor | 1/6W | 4.7k 1/6W 5% | 3 | yel-vio-red-gld | ![]() |
[ ] | Resistor | 1/4W | 4.99 k 1/4W 1% | 5 | y-w-w-br-br | ![]() |
[ ] | Resistor | 1/4W | 10 k 1/4W 1% | 11 | br-blk-blk-r-br | ![]() |
[ ] | Resistor | 1/4W | 22.1 k 1/4W 1% | 3 | r-r-brn-r-br | ![]() |
[ ] | resistor | 1/6W | 100k 1/6W 5% | 1 | brn_blk_yel_gld | ![]() |
[ ] | Resistor | 1/6W | 1 M 1/6W 5% | 1 | brn-blk-grn-gld | ![]() |
[ ] | SET | HDW | #6 screw, hex nut, starwasher | 1 | ||
[ ] | Transistor | TO-92 | 2N3904 NPN Transistor | 2 | 2N3904 | ![]() |
[ ] | Transistor | TO-92 | 2N3906 PNP transistor | 2 | 2N3906 | ![]() |
[ ] | Transistor | TO-18 | 2N2222 NPN transistor | 1 | ![]() | |
[ ] | Transistor | TO-92 | BS170 N-Channel Enhancement Mode FET | 6 | BS170 | ![]() |
[ ] | wire | Cutoff | shunt wire (cut-off lead) | 4 |